Agenda - Council - 11/26/2002 - Laserfiche WebLink

Home

-304- Amended Chapter 7007 I16/95 calculation itself. This calculation must include all emissions units at the stationat3, source, except for insignificant activities under part 7007.1300, and the information requked by subpart 4, item B, subitem (2), if continuous emissions monitor (CEM) data is used in the calculation. F. If the stationary source qualified in the permit application, in whole or in part, by using control equipment efficiencies for listed control equipment determined under'pm 7011.0070, thc owner or operator shall comply with parts 7011.0060 to 70I 1.0080. If the.calculations required by subpaxt 4 used control equipment efficiencies based on an alternative control efficiency under part 7011.0070, subpart 2, thc owner or operator shall also comply with thc operating parameters of the performance.test that established the alternative control efficiency. Gi The 12-month rolling sum of actual emissions from the stationary source determined pursuant to subpart 4 must not exceed the flu'esholds in subpart 5 for any. H. Comply with part 7011.1110. I. Comply with all applicable requkements including new source performance standards. J. If the calculation of actual emissions required by subpart 2, item E, for the application or by subpart 3, item E, for compl'iance verification exceeds five tons per year of sulfur dioxide or particulate matter less than ten microns, the owner or operator shall keep the following at the stationary source for all emission points venting to these emission units: (I) the location of thc emission points; (2) the potential emissions, as defined in part 7007.0150, subpart 4, in pounds per hour of sulfur dioxide and PM-10; and (3) thq gas flow rate and temperature, stack height, and diameter. Subp. 4. Calculation of actual emissions. The owner or operator of a stationary source may use a calculation worksheet provided by the commissioner for calculating actual emissions under this part, or may use the calculation methods under items A to E. The owner or operator must calculate actual emissions for each emissions unit, except that similar emissions Units may be aggregated for emission calculation purposes. The owner or operator of a stationary source shall use the calculation method in item B instead of the calculation method in item A if the data described in item B are available for the stationary source. The alternative methods described in items C, D, and E may be used by the owner or operator without advance notification to the commissioner. The commissioner shall reject data submitted using the methods described in items B to E if the conditions set forth for the method are not fully met. To prevent double counting of emissions, the owner or operator must select one calculation method Under this subpart for each emissions unit . at the stationary source. Fugitive emissions must be included in the calculations under this subpart. For purposes of this subpart, "emission factor" has the meaning given in part 7007.1200, subpart 3, item B. A. All calculations of actual emissions requked under this part shall be based on the stationary source's · operating parameters, and must use the following equation: E = OP x EF x 1-CE, where E = Actual Emissions in tons per year OP = Operating Parameter as required by the Emission Factor (hours of operation or units produced) EF = Emission Factor (pounds of pollutant per hour of operation or units produced). 67 I I I I I I' I I I I I I I I I I I I I