Laserfiche WebLink
EVENT: Fire Hydrant <br /> <br />EQUIPMENT REQUIRED: <br /> <br />Full Turnout Gear <br />Fire Hydrant <br />Torque Wrench for Steamer <br />40" x 40" Marked Area <br />Hydrant Wrench <br /> <br />(continued) <br /> <br />Candidate shall stand on the 40" x 40" designed area and shall remove the hydrant steamer <br />connection using the hydrant wrench. The steamer connection shall have a torque of 70 foot <br />pounds, as measured by a torque wrench prior to the start of each examination. The candidate <br />shall then open the hydrant valve using the hydrant wrench mining until the valve is fully open. <br />(The hydrant valve may have a torque range of 10 to 15 foot pounds.) During this examination, <br />the candidate shall maintain footing within the designated 40" x 40" area. <br /> <br />To pass this event, the candidate' shall remove the steamer connection and mm the hydrant <br />wrench eighteen (18) tums,or until the hydrant is open while standing within the designated <br />area. The event will be failed if the candidate steps out of the designated area, or fails to remove <br />the steamer connection or turn the hydrant the required number of turns, or open the valve (on an <br />"in-service" hydrant). <br /> <br />Nc:~lq 'v'~St Herv',ep~'l Courtly F~te Oeea'~rnem$ Prty$::.at A~fla¥ Tesl Az~ODIi~I 5/1/gfi <br /> 7 <br /> <br /> <br />