Agenda - Council - 12/10/2013 - Laserfiche WebLink

Home

.3 If a minor change in the Work is found necessary due to actual field conditions, the Contractor shall submit detailed drawings of such departure for approval by the Architect before making the change. Add the following clauses as Paragraph 1.2.4: .1 Whenever a product is specified in accordance with a Federal Specification, an ASTM Standard, an American National Standards Institute Specification, or other Association Standard, the Contractor shall present an affidavit from the manufacturer when requested by the Architect or required in the Specifications, certifying that the product complies with the particular Standard or Specification. When requested by the Architect or specified, support test data shall be submitted to substantiate compliance. .2 Whenever a product is specified or shown by describing proprietary items, model numbers, catalog numbers, manufacturer, trade names, or similar reference, no substitutions may be made unless accepted prior to execution of the Contract or if accepted as a change in the Work in accordance with Paragraphs 3.4.2. When two or more products are shown or specified, the Contractor has the option to use either of those shown or specified. PARAGRAPH 3.2 Add the following clauses to Paragraph 3.2.2: .1 The exactness of grades, elevations, dimensions, or locations given on any Drawings issued by the Architect, or the work installed by other contractors, is not guaranteed by the Architect or the Owner. .2 The Contractor shall, therefore, satisfy itself as to the accuracy of all grades, elevations, dimensions and locations. In all cases of interconnection of its Work with existing or other work, it shall verify at the site all dimensions relating to such existing or other work. Any errors due to the Contractor's failure to so verify all such grades, elevations, locations or dimensions shall be promptly rectified by the Contractor without any additional cost to the Owner. Add the following paragraphs to the end of Paragraph 3.2: 3.2.5 Except as to any reported errors, inconsistencies or omissions, and to concealed or unknown conditions defined in Paragraph 4.3.6, by executing the Agreement, the Contractor represents the following: .1 The Contract Documents are sufficiently complete and detailed for the Contractor to (1) perform the Work required to produce the results intended by the Contract Documents and (2) comply with all the requirement of the Contract Documents. .2 The Work required by the Contract Documents, including, without limitation, all construction details, construction means, methods, procedures and techniques necessary to perform the Work, use of materials, selection of equipment and requirements of product manufacturers are consistent with: (1) good and sound practices within the construction industry; (2) generally prevailing and accepted industry standards applicable to Work; (3) requirements of any warranties applicable to the Work; and (4) all laws, ordinances, regulations, rules and orders which bear upon the Contractor's performance of the Work. SUPPLEMENTARY CONDITIONS 00800-2