Agenda - Council - 05/13/2014 - Laserfiche WebLink

Home

7 LOCAL ISTS PROGRAMS 7082.0100 E. Provisions for design review, permit issuance, construction inspection, and system management. F. A provision that requires that all lots created after January 23, 1996, have a minimum of two soil treatment and dispersal areas that support systems as described in parts 7080.2200 to 7080.2230 or site conditions described in part 7081.0270, subparts 3 to 7, as applicable. G. A provision that specifies the conditions necessary to allow the use of holding tanks. The ordinance must specify holding tank operation and maintenance requirements. At a minimum, a monitoring and disposal contract signed by the owner and a licensed maintenance business is required unless the owner is a farmer exempt from licensing under Minnesota Statutes, section 115.56, subdivision 2 paragraph (b), clause (3). The homeowner is responsible for ensuring that the contract guarantees the removal of the tank contents before overflow or any discharge. H. A provision that prohibits surface discharge of sewage from SSTS unless issued a national pollution discharge elimination system permit by the agency. I. A provision specifying the allowable use and location of SSTS in floodplains in compliance with applicable state and local requirements. J. A provision requiring that a management plan be submitted by the designer to the local unit of government before issuance of a construction permit for all new or replacement ISTS as described in part 7080.1100, subparts 51 and 66. K. A provision requiring operating permits for all systems installed under parts 7080.2350 and 7080.2400 and chapter 7081. An operating permit is recommended for holding tanks regulated under part 7080.2290. L. For systems not operated under a management plan, a provision requiring solids removal from septic tanks or determination of the need to remove solids from septic tanks no less than every three years. The ordinance must require removal of solids if the solids accumulation needs to be removed based on part 7080.2450. M. A provision requiring that all owners of new or replacement Class V injection wells, as defined in Code of Federal Regulations, title 40, part 144, submit inventory information to the Environmental Protection Agency and the agency and that all Class V wells be identified as such in property transfer disclosures. N. A provision outlining how conflicting inspections and other technical disputes between SSTS certified individuals will be resolved if they occur as described in part 7082.0700, subpart 5. O. A provision specifying what level of local approval is needed for repair, rejuvenation, or remediation of SSTS, as defined in local ordinance P. A provision specifying the allowed methods to determine the loading rate from part 7080.2150, subpart 3, item E, Table IX or 1Xa, for sizing of soil treatment and dispersal systems. Q. A provision that requires all sewage generated in the jurisdiction to be treated either in an agency -permitted facility or a system that meets the requirements of an ordinance adopted under this chapter. R. If the ordinance allows a reduced vertical separation distance as described in part 7080.1500, subpart 4, item D, it must not allow more than a 15 percent reduction in the vertical separation distance to account for settling of sand or soil, normal variation of measurements, and interpretations of the limiting layer conditions. Copyright ©2014 by the Rev so of Statutes, State of Minnesota. All Rights Reserved.