Agenda - Council - 04/28/1992 - Laserfiche WebLink

Home

I ,I I '1 I I i I I I I i I I I I DUMP BODy: CAB SHIEI.,D: CITY OF RAMSEY EQUIPMENT SPECIFICATIONS ENDGATE iLength 10'; width 87" nominal capacity (struck) 6 c.y. Bottom to be not iless than 8 gauge steel. Side and ends to be not less than 10 gauge steel. :Ftoor to be supported with crossmembers every 12 inches and welded to ~the rub rail and interlaced to give floor support horizontally and ~longitudinally. Under structure to be structural channel. Body shall have 'tone piece full depth rear corner post and reinforced along top. Fully !boxed body top rail with font corner posts and tapered running boards. ~AII welds shall be continuous with no spaces for entraped moisture. Rear iof dump body shall be reinforced wilh a 3/16 full rear apron welded to ilong beams and rear comer posts. A safety prop meeting state and federal i requirements shall be furnished and installed. Include rear light ireceptacles recessed into rear corner posts. Rear lights shall have i removable lenses and replaceable bulbs. 11/2 cab shield (10 gauge) to be bolted on and recessed for exhaust stack. '[To be double acting type constructed of 10 gauge corten steel with i verlical and horizontal bracing. The gate shall include 3/8" coil proof 'r spreader chains, chain hooks top and bottom, pegs tor storing spreader chains when not in use, safety chain on dump lever, 1" flame cut [hardware and 1 1/4" minimum hinge pins. WALK R/~IL: MUD FLAPS: UGHTS: HOIST: HYDRAUI PUMP: To be 1 1/2" square tubing welded parallel between vertical side braces and 8" above bottom of rub rail. To be mounted rear of rear wheels. To meet D-O-T specification 108 with stop-turn-tail lights in rear. !corner posts (protected). Head lights to be high mounted on hood of vehicle with high-low beam to operate on same dimmer switch. Strobe ~ light to be mounted on cab shield with self leveling bracket. Wiring to be mounted in conduit. :Shall be NTEA class 50, double acting cylinder, Iow mount style. Lift to i be not less than 50 degrees. JC SYSTEM: i Front frame mounted, shall be direct driven by a spicer 1310 series .; driveline from the crankshaft of the engine. The hydraulic pump to be U.S. made, pressure/flow compensated (load sensing). Both compensators ~ must be screw adjustable. The pump must be capable of 23 G.P.M. at 3000 PSi at 2500 RPM, cessna model 70523 or equal. Shall be mounted outside and between frame rails. Shall be of sectional type, gresen model V30LS or approved equal. Valve shall be closed center load-sensing cabable of 30 G PM and 3500 PSi. Pilot line will run from valve outlet cover to pressure compensator on pump. Valve bank shall have 5 function - left to right: sander, hoist, plow, front wing, rear wing.