Agenda - Public Works Committee - 09/19/2017

Home

2.Odd Shaped Lots. For odd shaped lots such as exist on cul-de-sacs and curved streets where there is more than 2 feet of difference between the front and rear lot lines, and where the lots front footage shall be used. The adjusted front footage shall be computed by dividing the area of the lot by 12,000 square feet to determine the equivalent number of front footage units in the parcel. The number of units multiplied by 65 feet will give the adjusted front footage. 3.Corner Lot Adjustment. For street and trail assessments, the short side will be assessed the actual front footage. The long side will be assessed one-half the actual side footage. Sanitary sewer and watermain will only be assessed on the short side of a corner lot. 4.Zonal Assessment. When the street along the long side of a corner lot is improved, the cost shall be assessed equally to all lots within ½ block in each direction of the street improved. This method may be selected rather than the corner lot adjust. 5.Double Fronting Lots. When a lot has frontage on two streets, the lot is subject to assessments for improvements to both streets, consistent with this policy, regardless of the timing of the improvements. is based on the number of square feet or acres within the boundaries of the appropriate property lines of the parcels benefiting from the project. This method is most often applied to commercial and industrial lots. The assessment rate (i.e., cost per square foot) shall be calculated by dividing the total assessable cost by the total assessable area. On large lots, the City Engineer may determine that only a portion of the lots receives the benefit and may select a lot depth for the calculations equal to the benefit received. All properties included in the benefited area, including those owned by governmental entities, churches, etc., shall be assessable. The following items may not be included in area calculations: public right-of-ways, and natural waterways, swamps and lakes and other wetlands designated by the Minnesota Department of Natural Resources or the City. The City Engineer will make a recommendation on the boundaries or parameters of the benefited area in the feasibility report. is based on equal assessment of all lots within the benefited area. This method is typically applied to single-family residential lots with similar sizes and configurations. the total assessable lots or parcels benefiting from the improvement. For the purpose of those owned by governmental entities, shall be included in such calculations. SECTION 8. STANDARDS FOR PUBLIC IMPROVEMENT PROJECTS. The following standards are hereby established by the City to provide a uniform guide for improvements within the City. 7