Agenda - Council - 05/11/2021 - Laserfiche WebLink

Home

(118P0) ULTRA FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 06/20/2013 POOL SETUP (continued) • Next slide the vertical legs into the belt loop located in the middle of the pool liner. The bottom of the leg should be inside the white restraining rope (6) (optional) located near the liner's bottom edge. Carefully slide the leg into the belt loop and place the leg's bottom inside the rope and then insert the top of the leg into the bottom of the joint. Snap the leg into joint's holes by aligning the hole and the spring -loaded pin. Attach the leg's end cap (3) to the bottom of the leg (see drawing 3). • Grab the frame pool's top beams in 2 — 3 locations and "shake" the pool to be sure all the joints, legs and beams "fit into each other". • Pull gently, in an outward direction, the bottom of the leg making sure the leg is inside the restraining rope. • If pool was purchased with a filter pump, read the Krystal ClearTM Filter Pump Manual first and then proceed to next installation step. 3. Filling of the pool • Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check to see whether the water is level. IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging and a potential collapse of the pool. If the pool is not completely level, you must drain the pool, level the area or move the pool to a different area that is level, and re -fill the pool, following the above directions. • Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool sides meet. Or (from outside pool) reach under the side of the pool, grasp the pool floor and pull in an outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this process. IMPORTANT: For certain pool models with restraining rope at the bottom — Never pull from the restraining rope to smooth out the floor wrinkles as this may cause pool liner damage or leakage. • Fill the pool with water up to just below the sleeve line (see drawing 4). 4. Posting aquatic safety signs Select a highly visible area near the pool to post the Danger No Diving or Jumping sign included later in this manual. WATER LEVEL IMPORTANT Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that include, at a minimum, the important safety rules and general aquatic safety information in this manual. Review these rules on a regular basis and with all users of the pool including guests. The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool structure, all safety signs in accordance with the manufacturer's instructions. The safety signs shall be placed above the water line. SAVE THESE INSTRUCTIONS