Agenda - Council - 11/25/2025 - Laserfiche WebLink

Home

'''A MAGLIN® WOODSTOCK 3-468 Innovation Way, Woodstock ON N4V 0B9 T 800-716-5506 DENVER 99918th Street, #3000, Denver, CO 80202 F 877-260-9393 www.maglin.com sales c@i maglin.com PRODUCT INSTALLATION Maglin products must be installed according to the Maglin Product Installation Instructions. Damage occurring due to improper installation will not be covered under warranty. CLEANING, CARE AND MAINTENANCE We suggest regular inspections to identify any loose or missing hardware. These should be tightened or replaced immediately. If any part is found to be structurally cracked or broken it is recommended that the product be taken out of service until the appropriate repairs can be made. Contact Maglin for replacement parts. Should dirt from the environment build-up on any surface, wipe with a soft cloth and mild detergent. Abrasive and commercial cleaners, brushes or coarse steel wool should never be used on any surface. METAL All Maglin metal products are undercoated and powdercoated. The Maglin metal -finishing system has been designed and developed through the input of coating experts and more than thirty years of Maglin experience. It sets a standard for coatings and is unsurpassed for public site furniture. If the finish is marred by a sharp object and the steel is exposed, take a fine abrasive sandpaper to the area to improve the adhesion of the primer and touch-up paint. A quality grade exterior metal primer and topcoat of matching color enamel should then be applied over the prepared surface. Upon request, Maglin can supply metal paint samples for color matching. An alcohol -based sanitizer (not hand sanitizer, but one made for surfaces) is recommended for disinfecting surfaces. Powder coaters routinely test for full curing in QA via a solvent rub test using methyl ethyl ketone (MEK) which is a significantly more powerful solvent than alcohol. Disinfectant wipes (e.g., Lysol) are an alternative, however, a non -visible area should be tested prior to use. Pressure washing with a low PSI (1,000 PSI with a 36" distance from the surface) using filtered water and mild detergents work best. Commercial cleaning solutions can remove layers of the finish and should be avoided. Ground water use can result in staining. HDPE - HIGH DENSITY POLYETHYLENE Use lukewarm water and soap with a soft cloth, or sponge. We do not recommend any abrasive cleaners, or material, which can scratch or scuff the finish. LOCK MAINTENANCE To keep locks functioning properly especially in variable climates, the following is recommended. Use of a lock lubricant is advised every six months, especially in colder climates. Apply the lubricant onto the teeth of the key and insert into the lock and turn back and forth. This will transfer the lubricant from the key onto the lockset. Clean off key after finished. Depending on frequency of units being emptied, regular tightening of the mounting nut is recommended using a 7/8" wrench. This should be done minimum twice a year. Note: adding Loc-tite is not recommended. Failure to follow recommendations may result in having to purchase new locks. IPE WOOD Left alone, Ipe weathers naturally to a silver patina. Cracks and checking in the wood is normal and should be expected as it moves and breathes with the humidity in the air. This is the nature of the material and does not compromise strength or durability. Therefore, stain, varnish, urethane or paint is not recommended for exterior use as any finishing would require constant upkeep depending on climate. Deck Wise Ipe Oil use is recommended if upkeep is desired. There will be discoloration in raw Ipe as not all wood is taken from the same tree, this will result in some material being darker in appearance than others. THERMALLY MODIFIED ASH WOOD 2Maglin Site Furniture is the registered trademark of Maglin Site Furniture Inc. and Maglin Corporation