Laserfiche WebLink
<br />2. The property line of the real property on which the device is <br />being operated. <br /> <br />3. A distance of- 50 feet from any motor vehicle in which the <br />device is operating. <br /> <br />gg) To operate or to cause to be operated, but not limited to, the use of any noise <br />creating blower or power fan, internal combustion engine, air compressor or <br />steam engine, automobile, motorcycle, snowmobile, motor boat, motor bike, <br />scooter, recreational vehicle, all terrain vehicle, off highway motorcycle, off <br />road vehicle, go cart, or remote controlled airplane, boat, or other vehicle <br />powered by an engine or motor, the operation of which causes noise, unless <br />the noise from the blower or fan is muffled and such engine or compressor is <br />equipped with a muffler device sufficient to deaden and effectively prevent <br />such noise so that the noise shall not annoy, disturb or affect the comfortable <br />enjoyment of life or property. <br /> <br />1. Sound Levels. No person shall operate or cause or permit to be <br />operated any source of noise in such a manner as to create a noise level <br />exceeding the limit set in Table 1. <br /> <br />TABLE 1 <br /> <br />7:00 AM - 10:00 PM <br /> <br />10:00 PM -7:00 AM <br /> <br />Land Use <br />Residential <br />Commercial <br />Industrial <br /> <br />L50 <br />65 <br />70 <br />80 <br /> <br />LlO <br />60 <br />65 <br />75 <br /> <br />L50 <br />55 <br />70 <br />80 <br /> <br />LlO <br />50 <br />65 <br />75 <br /> <br />2. Measurement Procedure. The following procedures must be <br />used to obtain a representative sound level measurement by the use of <br />a sound measuring device: <br />a. A decibel meter will be used to obtain readings <br />and be used as evidence. <br />b. The operator of the device has sufficient training to <br />properly operate the equipment and can testify as to the manner in <br />which the device was set up and operated. <br />c. The device is operated with minimal <br />distortion or. interference from outside sources; and has been certified <br />as being accurate and reliable. <br />d. Measurements must be made at least three (3) <br />feet off the ground or surface and away from natural or artificial <br />structures which would prevent an accurate measurement. <br />e. Measurements must be made using an A- <br />weighting and fast response characteristics of the sound measuring <br />