Agenda - Council - 07/22/2008 - Laserfiche WebLink

Home

4.2.7 Brightness Limitations on Electronic Sims One of the main concerns about the use of electronic signs; regardless of «~hether they consist of changeable text; animation; or video, is the brightness of the image. The brightness of an object can be characterized in two ways. Ilumi~am~.ce is the total brightness of all the light at a point of measurement. Illuminance often describes ambient light and can be measured ~~,~itli a standard light meter such as is used in photography. Lul~~zn.a».ce is the measure of the light emanating from an object with respect to its size and is the team is used to quantify electronic sign brightness. The unit of measurement for luminance is nits;. which is tl7e total amount of light emitted from a sign divided by the surface area of the sign. (candelas per square meter).. Many, but not all, LED-type signage can be time-progranuned to respond to day and nighttime light levels. Higher-end signage types are equipped with photo cells to .respond to ambient light conditions. Despite these controls, LED signs have been observed that are considered to be excessively bright. Sig11 industry representatives indicate that excessive brightness can be the result of 1) sign malfunction or improper wiring, 2) lack of photo cell and/or dimming mechanism; or 3) operator error or lack of understanding that brightness is not necessarily an advantage, especially if it makes a sign unreadable or unpleasant to look at. They also maintain that the intent of the electronic sign industry is to establish a brightness level that is similar to a traditional internally or externally lit sign. Recent observations of sign technicians calibrating the hiterstate 394 LED billboard noted that the brightness controls are not calibrated to specific nit levels; but rather vary in proportion to a set maximum level, like a volume control dial on a typical car radio. To control the extent to `which electronic signs are a distraction or the extent to which they are readable, many local governments have adopted regulations that limit nit levels. At this time; ordinances that use nit level limitations typically differentiate bet«~een day time and night, time nit levels. A common daytime nit limitation ranges from 5;000 to 7;000 nits. A common nighttime limitation is 500 nits, although in areas that are extremely dark at night, with very little in the way of ambient light levels; less than 500 nits may be appropriate. Other communities have taken this farther, such as Lincoln, Nebraska; whose sign code incorporates a graph of ~~arying ambient light levels ranging from night time to a bright sunny day and all conditions betZ~~eeii those tv~~o extremes; and has correlating nit limitations for the various ambient light levels. es of re lations is challeritrin as luminance of electronic signs is very . Enforcement of these ~ p ~? ~ g difficult to measure in the field. Typically, sign luminance is measured and calibrated in a controlled factory setting using a spectral photometer to measure the light output. This calibration setting is then used in conjunction with a photo cell to control the brightness of the sign. The higher the ambient Iight levels, the brighter the sign. There axe different nit thresholds for various colors. White is most often used to set dimming levels because at a constant nit level; ~aThite has the most intensity as perceived by the human eye. Lincoln uses a light meter to conduct testing on electronic signs and found a wide range of luminance levels. One small electronic sign had luminance levels of 13;000 nits.. The process that Lincohl uses to check luminance levels is to hold a luminance meter close to the face of the sign so that it captures only the light emitted from the sign. They have not had any requests to X26 -234-