Laserfiche WebLink
City of Ramsey <br /> <br />15153 NC'WTHEN BOULEVAP, D N.W., RAMSEY, MINNESOTA 55303 <br /> <br />PHONE: (763) 4.27.1410 FAX (763) 4.27.5545 <br /> TOO (763) 4.27-8591 <br /> <br />I <br />I <br />I <br /> <br />December I, 2000 <br /> <br />Mike Schneider <br />Homestead Multi-Family Development <br />449 - 13'5'~ .Ave." ' ' ' <br />Foley, N2q 56329 <br /> <br />Re: Preliminary. Plat Review: Orchard Hills <br /> <br />Dear Nix. Schneider: <br /> <br />We are in receipt of your Preliminary Plat to develop a town~o.use project in Ramsey. The Preliminary <br />Plat consists of one (1) sheet dated November 10, 2000 prepared by TEC Design. We offer the <br />following comments: <br /> <br />General: The subject property consists of t~vo parcels rotating approximately 10.13 acres and is <br />generally located on the south side of 153a Avenue and east of Highway #47 (St. Francis Blvd.). The <br />Preliminary Plat is proposing 42 for-sale townhouses. In addition to a subdivision to reptat the <br />property, the townhomes will be subject to a site plan review for ali other aspects of the proposal <br />including but not limited to architectural standards, off-street parking, structure setbacks, and <br />landscaping. The proposed townhome development abuts a single-family, urban residential <br />development to the east and south. <br /> <br />Zoning'.. The property, is currently zoned R-3 Urban Residential, which allows up to 7 units per acre or <br />a max/mum of Yl units in this case. In the 12/21/99 draft comprehensive plan, the subject property is' <br />designated for development with high density residential uses and high density has been established at <br />a maximum of 7 units per acre. <br /> <br />Densiev: The maximum density allowed under the current zoning, current comprehensive pian, and <br />the dral5 comprehensive plan is 7 units per acre. The sketch plan identiI%s a total of 42 towniaomes, <br />which, equates to a gross density of 4.2 units per acre and a net density of 4.4 units per acre (net density <br />is calculated by subtracting Outlot A). <br /> <br />Lot Area: The City Code standards for lot sizes in the R-3 District are outdated and difficult to apply <br />to current development trends. However, the minimum amount of area required by the current <br />standards for the types of structures proposed would be 197,500 square feet. The area of the plat, <br />excluding the Outlor is 411,7.37 square feet. <br /> <br />-234- <br /> <br /> <br />