Laserfiche WebLink
Ramsy Fire <br /> <br /> CHASSIS SPECIFICATIONS <br />The chassis after frame dimension (A.E.) shall be min 84", measured from the centerline of the <br />rear axle to the end of the frame. <br /> <br />Maximum height of vehicle: ---" from ground <br /> <br />The height of the vehicle shall not exceed __" from the ground. <br /> <br />FUEL SYSTEM <br /> <br />The fuel tank shall have a capacity of 50 gallons, made of 12 gauge phosphate coated steel with <br />chromate epoxy exterior finish. Fuel tank must be I.C.C. approved with certification plate <br />attached. <br /> <br />The tank shall have vent port to facilitate rapid filling without "blow-back". An I.C.C. roll over <br />ball check vent shall be installed. <br /> <br />Dual draw tubes and dual sender ports shall be installed. 2" NPT fill ports shall be available for <br />left hand fill. A 1/2" NPT drain plug shall be centered in the bottom of the tank. <br /> <br />FRONT BUMPER AND EXTENSION <br /> <br />Front Bumper with 24" extension <br /> <br />ADV <br /> <br />BUMPER EXTENSION <br /> <br />A one-piece, polished stainless steel front bumper shall be provided. <br />high, two rib wrap-around type. <br />Hose tray mounted between frame rails to hold 100' of 1 3A" hose <br />The bumper shall be extended 24" ahead of the cab. <br /> <br />The bumper shall be a 12" <br /> <br />FRONT TOW HOOKS <br /> <br />Two chrome plated steel tow hooks shall be bolted to the frame under the front bumper. <br /> <br />(2) Air horns, Grover, CENTER BEHIND BUMPER <br />AIR HORNS <br /> <br />Dual air horns shall be installed behind the 24" front bumper extension. <br /> <br />Page 3 of 19 <br /> <br /> <br />