Agenda - Council - 12/10/2013 - Laserfiche WebLink

Home

PART 2 - PRODUCTS 2.1 METAL DOORS A. Type and design: Provide SDI-100 Grade III, Model I at exterior doors and Grade II, Model I at interior doors. Full -flush design in dimensions and types shown on the Drawings, labeled or non -labeled as indicted on the Door Schedule in the Drawings. Doors will be 18 gage for interior doors and 16 gage for exterior doors, properly reinforced for the finish hardware described in Section 08700 of these specifications. B. Finish: Pre -clean and shop prime each door for finish painting which will be performed at the job site under Section 09900 of these Specifications. C. Acceptable products: 1. Standard products of The Steelcraft Manufacturing Company. 2. Equal products of Amweld Division of American Welding and Manufacturing Company, Ceco Corporation, or other manufacturers when approved in advance by the Architect. 2.2 METAL FRAMES A. Type and design: Provide frames of the types and dimensions shown on the Drawings, labeled or non -labeled as indicated on the Door Schedule in the Drawings, in 16 gage for interior frames and 14 gage for exterior frames. Properly reinforce for the finish hardware described in Section 08700 of these Specifications. B. Finish: Pre -clean and shop prime each frame for finish painting which will be performed at the job site under Section 09900 of these Specifications. C. Acceptable manufacturers: See Paragraph 1.2-B above. 2.3 FINISH HARDWARE A. Secure templates from the finish hardware supplier, and accurately install, or make provision for, all finish hardware at the factory. PART 3 - EXECUTION 3.1 SURFACE CONDITIONS A. Examine the areas and conditions under which work of this Section will be performed. Correct conditions detrimental to timely and proper completion of the Work. Do not proceed until unsatisfactory conditions are corrected. 08100-2