Laserfiche WebLink
b) <br /> <br />Ground Signs. There shall not be more than one (1) ground sign for each lot. The gross <br />surface area of a ground sign shall not exceed one hundred (100) square feet for each <br />exposed face nor exceed an aggregate gross surface area of two hundred (200) square feet. <br />A ground sign may be located in any required yard but shall not extend over any lot line or <br />within fifteen (15) feet of any point of vehicular access from any zoning lot to a public <br />roadway. A ground sign shall not project higher than 20 feet, as measured from base of <br />sign or grade of the nearest adjacent roadway, whichever is lower. <br /> <br />c) Directional Signs. <br /> <br />Directional or Instructional signs are restricted to on-site direction and instruction <br />and shall not exceed four square feet. Such signs shall only provide direction or <br />instruction to guide persons to facilities intended to serve the public. <br /> <br />Parking lot directional signs designating parking area entrances and exits are limited <br />to one sign for each entrance and/or exit and shall not exceed four square feet for <br />each exposed face. Parking lot directional signs shall not project higher than five <br />(5) feet in height, as measured from the established grade of the parking area to <br />which such signs are accessory. <br /> <br />o <br /> <br />Parking tot instructional signs designating the conditions of use or identify of <br />parking areas shall not exceed 8 square feet and shall not project higher than 10 feet <br />in height for wall signs and 7 feet in height for ground signs, as measured from the <br />established grade of the parking area(s) to which such signs are accessory <br /> <br />9.12.10 OFFICE AND INDUSTRIAL PARK SIGNS. <br /> <br />a) Area Identification Signs. <br /> <br />Industrial or office park identification signs shall be permitted to contain the following <br />information: the name and address of the park, the management or the developer thereof, <br />and the names of the occupants of the premises on which the sign is to be located but <br />containing no advertising material of any kind shall be subject to the following: <br /> <br />1) All industrial and office park signs shall be ground or wall signs. <br /> <br />2) <br /> <br />There shall not be more than one (1) industrial or office park sign for each point of <br />vehicular access to an office or industrial park. <br /> <br />3) <br /> <br />The gross surface area of an industrial or office park sign shall not exceed fifty <br />square in gross surface area for each exposed face nor exceed an aggregate gross <br />surface area of one hundred (100) square feet, with an additional I0 square feet per <br />occupant or tenant listed on the sign. <br /> <br />4) <br /> <br />A ground industrial or office park sign shall not project higher than ten (10) feet, as <br />measured from base of sign or grade of the nearest adjacent roadway, whichever is <br />higher. <br /> <br />5) <br /> <br />A wall industrial or office park sign shall not project higher than the parapet line of <br />the wall to which it is to be affixed. <br /> <br />Sign Ord. Revised May 7, 1991 <br /> Page 14 of 20 <br /> <br /> <br />