Laserfiche WebLink
Subd. <br /> <br />Subd. <br /> <br />16 <br /> <br />17 <br /> <br />Specially designed pre-cast concrete units, if the surfaces have <br />been integrally treated with an applied decorative material or <br />texture. <br /> <br />Factory fabricated or pre-engineered steel and finished metal <br />framed panel construction, if the panel materials are any of those <br />named above, glass, pre-finished (other than galvanized iron), or <br />a plastic, and if there is a color retention guarantee of a minimum <br />of twenty (20) years, and if forty-two (42) inch full perimeter <br />frost footings are included. If any metal materials are utilized, <br />there must not be any exposed fasteners used and guard rails or <br />posts, curbs, or buffer strips must be installed to prevent impact <br />to the building. <br /> <br />The building design should exhibit building lines, shades, and <br />angles to enhance energy conservation. <br /> <br />F. Security lighting is required on the exterior of the building. <br /> <br />Exterior Maintenance of Buildings <br /> <br />Every exterior wall, foundation and roof of any building or structure shall be <br />reasonably watertight, weathertight and rodent-proof, and shall be kept in a <br />workmanlike state of maintenance and repair. Exterior walls shall be maintained <br />and kept free from dilapidation by cracks, tears or breaks or from deteriorated <br />plaster, stucco, brick, wood or other material that is extensive and suggests <br />neglect. The protective surface on exterior walls of a building above ground <br />level shall be maintained in good repair so as to provide a sufficient covering and <br />protection of the structural surface underneath against its deterioration. <br />Without limiting the generality of this section, a protective surface of a building <br />shall be deemed to be out of repair if (a) more than 25% of the area of any plane <br />or wall on which the protective surface is paint is blistered, cracked, flaked, <br />scaled or chalked away, or (b) more than 25% of the pointing of any brick or <br />stone wall is loose or has fallen out. <br /> <br />Plat and Plan Approval <br /> <br />Subdivision plats must be submitted to the City Planning and Zoning <br />Commission and the City Council in conformance with City subdivision <br />regulations prior to development in an Light Industrial District. <br /> <br />A site plan and security agreement shall be required pursuant to Section <br />170.017L of the zoning ordinance. <br /> <br />A complete set of building plans and specifications certified by a <br />registered architect and engineer, sewage disposal and water supply plans <br />must accompany the site plan. <br /> <br />No development shall be allowed until the Planning and Zoning <br />Commission has reviewed and made a recommendation and the City Council <br />has approved the deed restrictions for such a district and evidence of <br />filing such restrictions is given to the City Council. <br /> <br />11 <br /> <br /> <br />