Agenda - Council - 08/10/2004 - Laserfiche WebLink

Home

Co Divide the total floor area by tier computed in Item C. above by the average inside living area size determined in Item A. above. This yields a base number of dwelling units and sites for each tier. Proposed locations and numbers of dwelling units or sites for the commercial planned unit development are then compared with the tier, density and suitability analyses herein and the design criteria. Density Increase Multipliers: 1. Increases to the dwelling unit or dwelling site base densities previously determined are allowable if the dimensional standards are met or exceeded and the design criteria are satisfied. The allowable density increases in Item B. below will only be allowed if structure setbacks from the ordinary high water level are increased to at least 50 percent greater than the minimum setback, or the impact on the waterbody is reduced an equivalent amount through vegetative management, topography, or additional means acceptable to the local unit of government and the setback is at least 25 percent greater than the minimum setback. 2. .Allowable Dwelling Unit or Dwelling Site Density Increases for Residential or Commercial Plarmed Unit Developments: Density evaluation tiers Maximum density increase within each tier (percent) First 50 Second 100 Third 200 'Fourth 200 Fifth 200 Maintenance and Design Criteria 1. Maintenance and Administration Requirements. (a) Before final approval of a planned unit development, adequate provisions must be developed for preservation and maintenance in perpetuity of open spaces and for the continued existence and funCtioning of the development. (b) Open space preservation. Deed restrictions, covenants, permanent easements, public dedication and .acceptance, or other equally effective and permanent means must be provided to ensure long-term preservation and maintenance of open space. The instruments must include all of the following protections: (1) commercial uses prohibited (for residential PUD's); 29 -219-