Agenda - Council - 06/27/2017 - Laserfiche WebLink

Home

1. The Contractor shall furnish all sample materials required for these tests and shall deliver the same without charge to the testing laboratory or other designated agency when and where directed by them. D. Additional Tests 1. In addition to those tests required by the individual technical specifications and/or referenced specifications: (a) Additional tests required beyond these required under this specification may be ordered by the Engineer to settle disagreements with the Contractor regarding quality of work done. If the work is defective, the Contractor shall pay all costs of the additional tests and shall correct the work. If the work is satisfactory, the Owner will pay for the additional tests. (b) The Owner may perform televised inspection of any and/or all under construction included in this project, at its own expense, at any time prior to final payment. All deficiencies discovered in the course of such investigation shall be corrected at the Contractor's expense and, the Owner's satisfaction, prior to final payment. 1.4 ENGINEER'S REPRESENTATIVES AND TESTING A. The Engineer may provide a Resident Project Representative (RPR) to ascertain that the work is accomplished properly and in accordance with the plans and specifications. The RPR shall have full access to the work and shall be given full cooperation. The RPR shall have the authority, subject to the final decision of the Engineer, to reject any defective work or material. The RPR shall have no authority to permit any deviation from the plans and specifications except on written order from the Engineer. B. The presence of the Engineer or any RPRs, however, shall not relieve the Contractor of the responsibility for the proper execution of the work in accordance with all requirements of the Contract Documents. Compliance is a duty of the Contractor, and said duty shall not be avoided by any act or omission on the part of the Engineer or any RPRs. 1.5 SITE INVESTIGATION AND CONTROL A. The Contractor shall verify all dimensions in the field and shall check field conditions continuously during construction. The Contractor shall be solely responsible for any inaccuracies built into the work due to his failure to comply with this requirement. B. The Contractor shall inspect related and appurtenant work and shall report in writing to the Engineer any conditions, which will prevent proper completion of the work. Failure to report any such conditions shall constitute acceptance of all site conditions, and any required removal, repair or replacement caused by unsuitable conditions shall be performed by the Contractor at his sole cost and expense. 1.6 RIGHT OF REJECTION A. The Engineer, acting for the Owner, shall have the right, at all time and places, to reject any articles or materials to be furnished hereunder which in any respect, fail to meet the requirements of these specifications, regardless of whether the defects in such articles or materials are detected at the point of manufacture or after completion of the work at the site. If the Engineer or RPR, through an oversight or otherwise, has accepted materials or work which is defective or which is contrary to the specifications, such material, no matter in what stage or condition of manufacture, deliver, or erection, may be rejected by the Engineer for the Owner. PART 2 -- PRODUCTS (NOT USED) PART 3 -- EXECUTION (NOT USED) City of Ramsey - R16.111092 April 5, 2017 ****END OF SECTION**** QUALITY CONTROL PAGE 01450-2 V040110 © Bolton & Menk, Inc. 2016, All Rights Reserved