Agenda - Council - 06/27/2017 - Laserfiche WebLink

Home

SPECIAL PROVISIONS - SP20I6 BOOK Last Revision by CO Special Provisions: 2/08/17 (E) Constructing and milling tapers and/or chamfers shall be incidental. Created August 20, 2015 Page 15 SP 0202-101 (F) The Contractor shall maintain traffic with a minimum of delay during milling and paving operations at intersections controlled by signals or by all -way stop signs. The Contractor shall provide off -duty police officers, at no expense to the Department, to direct and control traffic around and through milling and paving operations at those intersections. "Police officer" means every officer authorized to direct or regulate traffic or to make arrests for violations of traffic rules. (G) The Contractor may close intersecting streets to traffic, other than at intersections controlled by signals or "All Way Stop" signs during milling and paving operations in the intersection, but only if there are adequate alternate routes for the intersecting street traffic. The Contractor shall not close adjacent intersecting streets to traffic concurrently. The Contractor shall notify the local road authorities of its schedule to close intersecting streets 48 hours in advance of the closure. S-12.7 MAINTENANCE AND STAGING OF TRAFFIC CONTROL (A) The Contractor shall maintain, at all times, the existing traffic movements. 1. Both accesses to Holiday Gas Station shall be open at all times. Two way traffic at the intersection of Ramsey Blvd and Riverdale Drive shall be maintained at all times. (B) Pedestrian traffic shall be maintained and guided through the Project at all times. See Section (C) The Contractor shall furnish, install, and maintain 2 "ROAD WORK AHEAD" and 2 "END ROAD WORK" signs in advance of and beyond each end of the construction limits as directed by the Engineer. The Contractor shall also furnish, install, and maintain 2 "ROAD WORK AHEAD" signs in advance of the construction limits on all intersecting roads and streets as directed by the Engineer. The signs shall conform to the standards shown in the MN MUTCD. Furnishing and erecting these signs shall be incidental. The signs shall remain the property of the Contractor. (D) The Contractor shall cover all signs that are not consistent with traffic operations. The cover should be a plate of solid material covering the entire legend or all of that part of the legend that is inappropriate. Bolt the cover to the sign and place a minimum of 1/8 inch spacers (such as plastic or rubber) between the sign face and the cover. See the Typical Temporary Sign Framing and Installation Details Sheet found in the Plan or at htt3://www.dot.state.mn.us/trafficeng/workzone/wz-temnlets/udf/lavout%2020.Ddf for details. This work will be done as required by the Engineer. (E) Street identification signage shall be maintained at all times. Where the only existing signs are small city or county signs located at the intersection, street names and address numbers shall be maintained by temporary installations as required by the Engineer. This is necessary to maintain the 911 emergency system. (F) The Contractor shall maintain a lane width of not less than 11 feet in each direction. In no case shall traffic be allowed or forced onto the shoulders as a result of the Contractors operations without prior approval of the Engineer. During the time of lane, speed, and pilot car restrictions, the Contractor's equipment shall follow in line and use the roadway in a manner similar to all other through traffic. (G) The Contractor may ban parking within the construction limits. All necessary signing is the responsibility of the Contractor and shall be installed, as directed by the Engineer, 24 hours prior to the parking ban. The Contractor shall remove that signing as soon as the work in the area has been completed. The Contractor shall notify the City of Ramsey at least 24 hours prior to posting any parking ban within the City.