Laserfiche WebLink
<br />1.A sheet specific legend is required listing all symbols and lines on this sheet. The legend <br />hatch does not match the plan view. <br /> <br />2.Obtain access agreements for removing temporary cul-de-sac on private property. <br /> <br /> <br />3.Sawcut and remove temporary cul-de-sac at end of curb. Sawcut and remove existing <br />driveways as needed to blend into new pavement. <br />th <br /> <br />4.Show removal of bituminous in 168 Avenue for construction of new services. Bituminous <br />must be sawcut and removed from curb to curb. <br /> <br />5.The notes refer to details that are not in the set, and sheets that are not in the set. <br /> <br />6.There is a tree removal symbol in the legend, it is not used on the plan. <br /> <br />7.A City demolition permit is required prior to performing work in Note 5. <br /> <br />8.The intent of Notes 10 and 13 is not clear. <br /> <br />9.Note 14 does not have a symbol on the plan view. <br /> <br />10. <br /> <br />11. <br />coordinated with connection to municipal se <br /> <br /> <br />C2.1: <br /> <br /> ALL SYMBOLS AND LINES <br />1.A sheet specific legend is required listing on this sheet. <br /> <br />2.Dimensions must be shown for the lots (bearing and length) and easements. <br /> <br />3.Drainage and utility easements must be labeled. <br />th <br /> <br />4.The existing hydrant at the end of 168 Lane is called out for removal on the removals <br />sheet. It must no appear on any other sheet. <br /> <br />5.The overflow swale and sawcut lines must be turned off on this sheet. <br /> <br />C3.1: <br /> <br /> ALL SYMBOLS AND LINES <br />1.A sheet specific legend is required listing on this sheet. <br /> <br />2.Soil borings are required in the infiltration areas and in the house pad areas to establish <br />groundwater elevations. <br /> <br />3.The lowest floor elevation must be at least 3 feet above the highest anticipated groundwater <br />elevation, 2 feet above the 100 year flood elevation <br /> <br />4.The minimum grade on all lots in all directions shall be 2.0% or greater. <br /> <br />5.Show proposed elevations at all lot corners. <br /> <br />6.Silt fence must stand out on this sheet. <br /> <br />7.The lowest floor elevation label must be the same size as the other elevations in each pad. <br /> <br />8.Provide detail for Enkamat. <br /> <br />9.Add silt fence at top of slope around infiltration basin. This will be installed after the basin <br /> <br />is excavated. <br /> <br />10.on shall be <br /> <br /> <br /> <br />11.Show inlet protection for curb cut to be installed after curbs are backfilled. <br /> <br />12.Update the Lot Elevations table to match the elevations shown on the pads. Verify the <br /> <br />backyard slope on lot 7. <br />th <br /> <br />13.Show grading for sidewalk along north side of 168 Lane. <br /> <br />14.Add the rock construction entrance to the legend. <br /> <br />