Agenda - Council - 02/12/2018 - Laserfiche WebLink

Home

ADDENDUM NO. 1 IP 18-08 TROTT BROOK BOARDWALK CITY OF RAMSEY Page 4 of 5 equipment covered by an application for payment will have been acquired by the Contractor or by any other person performing the Work at the Work site or furnishing materials and equipment for the Project, subject to an agreement under which an interest therein or encumbrance thereon is retained by the seller or otherwise imposed by the Contractor or such other person. The Owner will, within fifteen (15) Calendar Days after receipt of application for payment, either indicate in writing approval of payment and present the application to City Council for payment, or return the application to the Contractor indicating in writing reasons for refusing to approve payment. In the latter case, the Contractor may make the necessary corrections and resubmit the application. Bid Specifications/ Responses to Clarifying Questions Project Scope • Under #1. (Project Scope), references that 'Each section shall be through -bolted in at least four places to the adjoining section.' These bolts shall be galvanized or zinc plated, with hexagonal or carriage bolt style heads, and minimum of 1/2' inch in diameter, with corresponding flat washer and nut. • Traverse decking shall receive two 1/4 x 32 GRK Structural Screws per joist crossed, and two at each deck board end. • Regarding Elevated Curb Detail, the 2" x 4" curb shall be either 8' foot or 16' foot in length with the ends cut at alternating 45 degrees, and overlapping, over a 6" 2" x 4" block as specified, approximately 32" inches on -center. • Elevated curb screws (both curbing and blocks) shall be 3" Deckmate T-25 Star Drive coated screws, or approved equal. • Under #3. (Material Specifications), Structural dimensional lumber shall be 'graded in accordance with National Design Specifications for wood construction' and sanded four sides, and not rough sawn lumber. • 'All lumber shall be pre -stained brown, or stained brown on site'. There is no additional stain specification to be considered here —other than the color to be generally considered medium brown, and of uniform consistency in coverage (pre -stained brown as part of the pressure treating process, or stained brown on site).