Agenda - Parks and Recreation Commission - 09/14/2023

Home

1.8.2. Weld plate panel connections shall be grouted flush with interior wall surface. Speed Crete Red Line or equal. 2. FINISHES 2.1. Interior 2.1.1. Smooth trowel finish. 2.2. Exterior 2.2.1. Exterior wall appearance to be approved by owner using an architectural form liner. 2.2.2. Roof shall be cedar shake architectural form liner. 2.3. Paint 2.3.1. Interior 2.3.1.1. Wall panels shall be primed with a premium quality water based acrylic bonding primer moisture and alkali resistant. Finish coat shall be a high performance acrylic enamel. 2.3.2. Exterior 2.3.2.1. Roof shall be covered with a quality 100% acrylic satin paint. Owner to determine color. 2.3.2.2. Walls shall be covered with a quality concrete stain. Owner to determine color. 2.3.2.3. Doors shall be covered using 2 coats of a high performance 100% acrylic satin enamel. Owner to determine color. Part 3 — Execution 1. PRECAST CONCRETE FAMILY STYLE RESTROOM —SHOWER BUILDING 1.1. Building manufacturer shall construct, assemble, paint, install plumbing and electrical at their plant so that it may be transported to the jobsite in finished modules and placed using a crane. 1.2. Building manufacturer shall provide mechanical rough in drawing showing where electrical, water supply line, waste line, and floor drains are to be located for hook up to building. 1.3. Contractor will make final mechanical connections after the building is placed by manufacturer. 1.4. Manufacturer will caulk interior and exterior seams between modules. Manufacturer will also perform any shipping and handling repairs during installation. 2. ONSITE 2.1. Contractor shall provide adequate access and a level pad for the crane and semis to sit side by side under their own power. Working radius shall be 35' from center pin on crane. 2.2. Contractor shall design and pour a foundation suitable for building to sit on. Foundation shall be level to within %".