Laserfiche WebLink
1 <br />2 <br />3 <br />4 <br />5 <br />6 <br />7 <br />8 <br />9 <br />10 <br />11 <br />12 <br />13 <br />14 <br />15 <br />16 <br />17 <br />18 <br />19 <br />20 <br />21 <br />22 <br />23 <br />24 <br />25 <br />26 <br />27 <br />28 <br />29 <br />30 <br />31 <br />32 <br />(A) Wall lighting may be used to illuminate the pedestrian walkways, entrance areas, loading docks, and <br />yard areas within 20 feet of the building. No wall lighting may be used exclusively to illuminate areas <br />for motor vehicle parking or access. <br />(B) Architectural lighting, including LED or neon banding, must be mounted on the building or canopy. <br />Architectural lighting directed upward onto the building facade is permitted provided no glare or <br />light pollution are produced. LED banding must use colored tube shielding for a continuous <br />appearance. <br />(C) Free-standing and wall -mounted luminaire regulations: <br />(1) Height maximums, including the base and support structure, are limited as follows: <br />a. Farther than 200 feet from any property zoned residential: 30 feet. <br />b. Within 200 feet of any property zoned residential: 15 feet. <br />(2) Cut-off angles must be equal to or less than 90 degrees. <br />(3) Ballfield, stadium, or outdoor recreation lighting is exempt from the height and cut-off angle <br />requirements in this section though the design shall constitute the absolute minimum height <br />necessary to light the area and must provide shielding to reduce off -field light spill. <br />(D) Lighting intensity must adhere to the following table: <br />Required Minimum and Maximum Light Intensities <br />(as measured in foot candles at the ground level) <br />Use <br />Minimum <br />Intensity <br />Maximum <br />Intensity <br />Maximum <br />Intensity at <br />Property Line <br />Parking areas for non-residential uses <br />1 <br />15 <br />0.5 <br />Parking areas for multi -family residential uses <br />1 <br />15 <br />0.5 <br />Private pedestrian walkways for non-residential <br />and multi -family residential uses <br />5 <br />20 <br />0.5 <br />Building entrances and exits <br />5 <br />20 <br />0.5 <br />Exterior storage areas <br />0.5 <br />15 <br />0.5 <br />Vehicle sales lots <br />1 <br />20 <br />0.5 <br />Non -specified uses - For uses not specifically listed above, light requirements may be computed by the <br />zoning administrator. <br />(E) Exterior lighting must be operational when a business is open or employees are on site. <br />(F) Glare. All lighting must be arranged so as not to produce glare. All properties must be in <br />compliance with the following: <br />(1) All light sources must be controlled and equipped with lenses, louvers, shields, or prismatic <br />control devices designed to prevent off -site views of the light source. <br />(2) No flickering or flashing lights except those associated with public safety activities may be <br />permitted. <br />(3) Light sources that are integrated into a canopy must be designed to be recessed and flush <br />with the ceiling of the canopy, and equipped with a flat lens surface. <br />(4) Residential single-family and townhome uses may have wall -mounted lighting with exposed <br />light sources provided glare is not produced from off -site views. <br />(G) Compliance. Any new lighting installed after the effective date of this chapter must be in <br />compliance with the requirements of this chapter. Any lighting in existence before the effective <br />date of this chapter that does not comply with its requirements may be considered legally <br />Page 37 of 160 <br />