Agenda - Council - 03/12/2024 - Laserfiche WebLink

Home

considered for prior approval of the architect, provided the required data and physical samples are submitted for approval as set forth in Division One General Requirements. B. Where indicated in this specification, products shall be independently certified by ANSI for compliance with relevant ANSI/BHMA standards A156.1 -A156.36—Standards for Hardware and Specialties. All products shall meet or exceed certification requirements for the respective grade indicated within this specification. Supplier shall provide evidence of certification when requested by the architect. C. Obtain each type of hardware (hinges, latch & locksets, exit devices, closers, etc.)from a single manufacturer, although several may be indicated as offering products complying with requirements. D. Electrical drawings and electrical specifications are based on the specific electrified hardware components specified in hardware sets. When electronic hardware components other than those indicated in hardware sets are provided, the supplier shall be responsible for all costs incurred by the design team and their consultants to review and revise electrical drawings and electrical specifications. Supplier shall also be responsible for any additional costs associated with required changes in related equipment, materials, installation, or final hook up to ensure the system will operate and function as indicated in the construction documents, including hardware set operational/functional descriptions. E. All hardware items shall be manufactured no earlier than 6 months prior to delivery to site. F. Hardware supplier shall be factory trained and certified by the manufacture to provide and support all computer managed locks and system components. G. Installation of hardware shall be installed or directly supervised and inspected by a skilled installer certified by the manufacturer of locksets, door closers, and exit devices used on the project, or with not less than 3 years' experience in successful completion of projects similar in size and scope. H. Provide hardware for all labeled fire doors, which complies with positive pressure fire testing UL 10C. I. Comply with all applicable provisions of the standards referenced within section 1.4 of this specification. J. Hardware supplier shall participate when reasonably requested to meet with the contractor and or architect to inspect any claim for incorrect or non-functioning materials; following such inspection, the hardware supplier shall provide a written statement documenting the cause and proposed remedy of any unresolved items. 1.7 DELIVERY, STORAGE AND HANDLING A. Hardware supplier shall deliver hardware to the job site unless otherwise specified. B. All hardware shall be delivered in manufacturers' original cartons and shall be clearly marked with set and door number. C. Coordinate with contractor prior to hardware delivery and recommend secure storage and protection against loss and damage at job site. D. Contractor shall receive all hardware and provide secure and proper protection of all hardware items to avoid delays caused by lost or damaged hardware. Contractor shall report shortages to the Architect and hardware supplier immediately after receipt of material at the job site. E. Coordinate with related trades under the direction of the contractor for delivery of hardware items necessary for factory installation. 1.8 PRE-INSTALLATION MEETING Ramsey Water Treatment Plant 0871 00 - 3 DOOR HARDWARE Ramsey, Minnesota