Laserfiche WebLink
<br />. . <br />d. The gross surface area of a ground sign shall not exceed .one hundred (l00) <br />square feet for each exposed face nor exceed. an aggregate gross surface area <br />of two hundred square feet. <br /> <br />e, A ground sign shall not -project higher than ten (10) feet, as measured from <br />based of sign or grade of the nearest adjacent roadway, whichever is. higher. <br /> <br />9.12.11 <br /> <br />Planned Unit Developments <br /> <br />Subdivision 1. 'The developer shall be required to submit a sign plan for <br />approval, drawn to scale .with elevations. The sign plan shall include but not be limited to the <br />. following information: number of signs, type of signs, sign sizes, type of construction materials, <br />and sign messages. <br /> <br />.9.12.12 <br /> <br />Construction Specifications <br /> <br />Subdivision 1. All signs permitted by ~s Section in excess of sixteen (16) <br />square feet shall be painted, lettered, or faced to the workmanship standards and best commercial <br />practices of companies normally engaged in the business of providing commercial signs, using <br />materials designed and marketed specifically for use on 9utdoor signs. . <br /> <br />Subd.2. In addition to complying with the provisions of this ordinance, all signs <br />shall be constructed in accordance with the applicable provisions of the 1991 Edition of the <br />Uniform .Sign Code and State Electrical Code and as subsequently ame~ded. <br /> <br />Subd. 3. All signs shall be located. in such a way that they maintain horizontal <br />and vertical clearance of all electrical power lines and communication lines. <br /> <br />, . . Subd. 4. All signs and their supporting structures shan maintaln clearance and <br />.nqn-interference with all surface and underground facilities and. conduits for water, sewage, gas, <br />electricity, or communications equipment or lines. In addition, the placement of all signs and <br />their supporting structures shall not interfere with natural or artificial drainage or suiface or <br />underground water.' . <br /> <br />Subd. 5. All signs;. except those attached flat against the wall of a building shall <br />be constructed to withstand minimum wind loads as follows: <br /> <br />a. Solid Signs. Thirty (30) pounds per square foot per. face of the sign. <br /> <br />b. Open Signs. Thirty-six (36) pounds per square foot of the total face area of' <br />the letters and other sign surfaces, or ten (10) pounds per square foot of the <br />gross surface area of the sign, whichever is greater. <br /> <br />.9,12.13 <br /> <br />Non-conforming Signs <br />