Agenda - Council - 09/27/2016 - Laserfiche WebLink

Home

3.05 PRODUCT DATA A. Collect Product Data into a single submittal for each element of construction or system. Product Data includes printed information, such as manufacturer's installation instructions, catalog cuts, standard color charts, standard wiring diagrams, applicable certifications and performance curves. Mark each copy to show applicable choices and options. Where printed Product Data includes information on several products that are not required, mark copies to indicate the applicable information. 3.06 SAMPLES A. Submit full-size, fully fabricated Samples cured and finished when specified and physically identical with the material or product proposed. Samples include partial sections of manufactured or fabricated components, cuts or containers of materials, color range sets, and swatches showing color, texture, and pattern. Mount or display Samples in the manner to facilitate review of qualities indicated. 3.07 QUALITY ASSURANCE AND QUALITY CONTROL SUBMITTALS A. Submit quality assurance and quality control submittals, including design data, certifications, manufacturer's instructions, manufacturer's field reports, materials test results, field testing and inspection reports, and other quality -control submittals as required under other Sections of the Specifications. B. Certifications: Where other Sections of the Specifications require certification that a product, material, or installation complies with specified requirements, submit a certification from the manufacturer or responsible engineer certifying compliance with specified requirements. C. Calculations: When required in the technical specification, calculations shall be prepared and signed by a Professional Engineer registered in the State of Minnesota. 3.08 ENGINEER/ARCHITECT'S ACTION A. Except for submittals for the record, or for information where action and return is not required, Engineer will review each submittal, mark to indicate action taken, and return within the time frame specified in Paragraph 3.1.A.3. 1. Compliance with specified characteristics is the Contractor's responsibility. B. Action Stamp: Engineer will stamp each submittal with a uniform, action stamp. Engineer will mark the stamp appropriately to indicate the action taken, as follows: 1. "Reviewed": the Work covered by the submittal may proceed provided it complies with requirements of the Contract Documents. Final payment depends on that compliance. 2. "Reviewed with Comments": the Work covered by the submittal may proceed provided it complies with notations or corrections on the submittal and requirements of the Contract Documents. Final payment depends on that compliance. 3. "Revise and Resubmit" or "Rejected": do not proceed with Work covered by the submittal, including purchasing, fabrication, delivery, or other activity. Revise or prepare a new submittal according to the notations and resubmit without delay. Repeat if necessary to obtain different action mark. a. Do not use, or allow others to use, submittals marked "Revise and Resubmit" or "Rejected" at the Project Site or elsewhere where Work is in progress. 4. Other Action: Where a submittal is for information, or for record purposes, or for special processing, or for other activity, the E/A will return the submittal marked "Record Copy", "Action Not Required" or "No Action Taken." C. Unsolicited Submittals: The E/A will return unsolicited submittals to the sender without action. Division 1— General Requirements DV 1-3