Agenda - Council - 06/27/2017 - Laserfiche WebLink

Home

SPECIAL PROVISIONS - SP20I6 BOOK Last Revision by CO Special Provisions: 2/08/17 S-37.2 All materials furnished under this specification shall be new. Created August 20, 2015 Page 53 SP 0202-101 S-37.3 Prior to its installation, the hydrant shall be cleaned of all foreign matter and after installation shall be disinfected in accordance with the procedures described in paragraphs No.'s 1227 and 1228 of Section XII "Manual of Water Supply Sanitation" of the Minnesota Department of Health. S-37.4 Hydrant installation will be measured by the number of hydrants installed complete as specified. Payment will be made under Item 2504.602 (Hydrant) at the Contract bid price per each, which shall be compensation in full for all costs incidental thereto including, but not limited to any additional water leads, drain pits, concrete blocking, extensions, risers or fittings necessary to complete the new installation. S-38 (2504) INSTALL VALVE AND BOX This work shall consist of installing a new valve and box in accordance with the applicable MnDOT Standard Specifications, as detailed in the Plan, and the following: S-38.1 See Section 02510 for additional valve and box specifications. S-38.2 Prior to installation, the valve and box shall be cleaned of all foreign matter and after installation shall be disinfected in accordance with the standard procedures of the Minnesota Department of Health. S-38.3 Measurement will be made by the number of valves and boxes installed as specified. Payment will be made under Item 2504.602 ( " Gate Valve and Box) at the Contract bid price per each, which shall be compensation in full for all costs incidental thereto to install the valve and box complete and inplace. S-39 (2504) ADJUST VALVE BOX This work shall consist of adjusting existing valve boxes to new surface elevations without changing the elevation of the valves. The work shall be performed to the satisfaction of the Engineer in accordance with the following: Measurement will be made by the number of boxes adjusted. Payment will be made under Item 2504.602 (Adjust Valve Box) at the Contract bid price per each, which shall be compensation in full for all costs incidental thereto including, but not limited to, furnishing extensions as required and replacing any materials damaged by the Contractor's operations. S-40 (2504) WATERMAIN PIPE AND FITTINGS S-40.1 See Section 02510 for specifications related to watermain pipe and fittings. S-41 (2504) POLYSTYRENE INSULATION This work shall consist of furnishing and installing 4 inch thick insulation board above the watermain at the locations designated in the Plan. This work shall be performed in accordance with the details shown in the Plans, the applicable MnDOT Standard Specifications, and the following: S-41.1 The insulation board shall be rigid expanded polystyrene conforming to the material requirements of MnDOT 3760. Styrofoam S.M. and Styrofoam TG brand insulation is an approved insulation material. S-41.2 The insulation material shall be furnished in panels 1 inch [25 mm] thick and shall be placed on a smooth level foundation in a staggered manner that will provide joint overlaps a minimum of 6 inches [150 mm] on the underlying sheets and the edges shall be trim and square. A minimum of two (2) wood skewers per board in each